Weird error - HTTPIO_ERROR_CUSTOM_MYSAPSSO ...?

[Former Member]

Hey Guys,

I see this issue is bugging me, I can't go ahead for doing for next.

My scenario: PROXY to SOAP (Syncronous) :

I was through with the build, when I tried to test it out from RWB then I see this below error. I am trying to push the payload with the best effort -Exactly Once. I already dived into the SDN for similar kind of posts, but I hardly see these below ones.

Error While Sending Message: Error stack from response: Error while sending by HTTP (error code:  35 , error text: HTTPIO_ERROR_CUSTOM_MYSAPSSO-Fehlermeldung beim Senden der Daten.)

Error While Sending Message: Error stack from response: Error while sending by HTTP (error code: 35 , error text: HTTPIO_ERROR_CUSTOM_MYSAPSSO-Fehlermeldung beim Senden der Daten.)

Can some one really had experienced this kind of issue, please share your answers.

I really appreciate for your views.

Regards

Nag.

[Former Member]

Check param:

login/accept_sso2_ticket    =    1          

login/create_sso2_ticket     =      2        

[former_member336976]

Hi ,

Go to transaction SSO2 and give RFC of System aliase.then Execute.

Check these parameters on the screen :

login/accept_sso2_ticket    =    1        

login/create_sso2_ticket     =      2      

if these are not same,maintain it n Rz11.

then go to Edit menu ,just click enter certificate,enter ACL and enter SAP CA.

Save data.then check your OData in Gateway client.

Appreciate your response.

Best regards,

Siva.

[Former Member]

thanks

[Former Member]

Hi,

Did you solve this issue? Can you please share how you resolved this issue? I am having this same issue.

Thanks,

Sangita

[Eoin_Kierans]

What is the value within your system for the parameter 'login/create_sso2_ticket', you can check this within RZ11.

Does this scenario use Principal Propagation?

[Shabarish_Nair]

where are you getting this error?

In the sender ABAP system or in PI?

[Former Member]

PI 7.1 Version

Hi Vijay,

Am testing out this from RWB. Which means am not triggering the interface end to end. So, I can't see any message at source system ECC.

So, I see this in PI system itself.

Thanks.

[Shabarish_Nair]

1. could you initiate a test from the source system and confirm?

2. Are you testing from RWB -> component monitoring -> Integration Engine -> Test message?