Behaviour of selection opening in DP Planning grid

[Former Member]

Hello,

I have one question about the behaviour of a selection opening in a DP planning grid:

In my DP planning grid I have 2 defined selections (selection A and selection B) in my selection choice view. Both selections have approx. 100 data records. If I want to load selection A in the planning grid, the loading action takes several seconds. If I load selection B in the planning grid it only takes at most 1 second.

I do not need a solution for this behaviour, but I need an explanation. Are there any reasons which can explain this behaviour?

Thanks for your answers in advance!

Kind regards

Heinz Becker

[former_member187488 · Accepted solution]

Hello,

Do you have navigational attributes in selection A?

It may also slow down the performance.

What if you open selection A for a second time? And what if you open selection B then selection A?

Best Regards,

Ada

[Former Member]

Ok, thanks for your answer!

This might be some reasons.

But I recognize that the structure of both selections is the same. Are there any other possible reasons, too?

Perhaps some LiveCache reasons?

Kind regards

Heinz Becker

[m_manimaran]

Hi,

This may be due to many reasons. I will list out my understandings,

1. The selection A might have wild cards, which may take more time than the direct entries

2. The selection A may have exclusion rules, which will also take more time

3. The selection may be at the more detail level than the other selection

Regards,

Manimaran M.