Recorded for outbound processing

[Former Member]

Hi

I get this error, " Recorded for outbound processing ", when I run the interface. When I go to the queue, it says SYSFAIL. I updated cache and all.

How do I resolve this error?

Ajith

[monicabhosale]

Hello,

If you are facing SYSFAIL Error then in SMQ2 first unlock(without activation) that queue and activate it.

it will resolve your problem.

Monica

[Former Member]

Hi

I have noticed one strange configuration. The same set of interfaces has been configured for different flows between SRM and SUS. I guess that's why messages are going into " Recorded for outbound processing " state. It's like this, SupplierPartner_out is the sender interface in one scenario and SupplierPartner_In is the receiver interface in one scenario. Here the flow is from SRM to SUS. In the next flow, SupplierPartner_out is the sender and added to SUS, SupplierPartner_In is the receiver in second and its added to SRM. Two scenarios are configured exactly opposite. RA, Receiver Com Channels are all configured accordingly.

So will one work if I dfelete the other scenario ?

Regards

[former_member303666]

hi ahith,

visit the below link for small inf...

http://saptricks.com/smq1-outbound-queue-statuses/

thanks and regards,

kesava