Unit of measure in APO DP planning Book

[Former Member]

Hi All,

We are using LB as Base unit of measure in product master and same is used as Unit of measure for DP planning area. I would like to use two different key figures in DP planning book where one key figure should display LB as UoM and other should display CS.

How do I achieve this? I tries check box option in keyfigure details screen in planning area but it does not help since Base unit of measure is same in product master and planning area.

Any help would be greatly appreciated.

Regards,

Harshil Desai

[Former Member · Accepted solution]

Harshil,

Maintain alternate unit of measurement in the Product master and then assign the alternate unit-CS in Planning book for the 2nd KF as CS by going to the design tab/option from Planning book.

Thanks

Hari Vomkarey