on 09-06-2011 7:35 AM
I have created a status profile to prevent the user from accessing usage decison till results recording is done.So in the final status where the user is allowed to do usage decison i have given the action "Close inspection - complete" as the triggering action.Now on doing inspection after results recording the status of the lot is being shown as INSP RREC SPRQ.But the status profile status is not changed.Given below is the status profile that i have created.
status number status lowest Highest
10 QPIN Initial Status 10 20 1 1
20 QFIN Final Status 20 20 1 1 .
****************************\ QPIN | QFIN
Access usage decision \ forbidden | allowed
Close inspection - complete \ allowed | allowed Set
Make usage decision \ forbidden | allowed
Print Sample-Drawing Instructn \ forbidden | allowed
Print inspection instruction \ forbidden | allowed
Record inspection results \ allowed | allowed
Record long-term characterist. \ allowed | allowed
Start inv. pstg bef. UsageDec \ forbidden | forbidden
Edited by: gjravinh on Sep 6, 2011 8:36 AM
Edited by: gjravinh on Sep 6, 2011 8:38 AM
Edited by: gjravinh on Sep 6, 2011 8:39 AM
First go to the UD screen and in the UD select the following:
Edit>Inspection completion>Complete.
You must force close any open charcteristics. It should ask you this. You should say YES.
Then you should see the status ICCO on the inspection lot. Since you don't see the status ICCO on your current lots according to your posting, you have not yet sucessfully "completed" the inspection lot.
FF
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
89 | |
7 | |
7 | |
4 | |
4 | |
3 | |
3 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.