adding a new key figure to a SNP planning area

[Former Member]

Hi,

I want to add a new key figure to a SNP planning area that is already initialized. Should I de-initialized it? after de-initialized is the master data lost?

Thanks a lot

[aparna_ranganathan · Accepted solution]

Hi

There are a lot of posts in the forum related to this issue. Anyways if you are on SCM 5 , you need not deinitialize the planning area to add new key figure. If you make changes to key figure settings then the data wont be lost. But to be on the safer side , you can back up data to your cube , add the key figure and if there are any errors , you can always deinitialize the p.a , re-initialize it and load data back from your cube

Thanks

Aparna