Extract Initial Values for the SNP PLanning Book/Planning Area

[Former Member]

Hi Gurus,

We have a requirement in which we need to create a report which will show some data in the planning book.

SOme data in the planning book are only calculated by macro so we need to get the Key figures for the calculation of this data. Our requirement is to show the Day's supply key figure in the report which would need the Stock On hand quantity for the calculation.However we are having problem on how extracting the correct data for the key figure.

There is a initial values in the planning books which are the data in the past like ATD Receipt, Demand,other receipts, etc. Would like to know how can I extract this initial values in the planning book/planning area? Are there any BAPI, function module I can use?

Thanks a lot,

Raymond

[syed_hassan2 · Accepted solution]

Raymond,

Goto your planning area, tab key figure and try to use this indicator given below to see if initial values get extracted.

Indicator: Read Initial Data

Use

Used primarily in Supply Network Planning, you decide in this field if past data is to be taken into account when planning. This field is then relevant, if you have stored your key figures in time series in liveCache.

If you enter X, the system reads the initial data, that is, all past data.

regards,

Najam