on 08-26-2011 9:42 AM
Hello everybody,
i am wondering if it is possible to use a receiver rule within an integrated configuration?
If not, is there an adequate alternative in integrated configurations?
Best regards,
Markus Schalk
Hi Markus,
You cannot configure communication scenarios that contain, for example payload-based routing or a message split, with Integrated Configuration. You must define separate receiver determinations, interface determinations, and communication agreements to configure communication scenarios of this type.
You can only use Integrated Configuration to set up communication scenarios where the message is only to be transferred within an Adapter Engine from a sender to a receiver adapter.
Please take a look at the following URL for the Use of Integrated Configurations:
http://help.sap.com/saphelp_nwpi71/helpdata/en/46/69f88453070ea1e10000000a155369/content.htm
Hope this helps.
Regards, Gaurav
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello Markus,
Do you want to say receiver determination condition?
if you are talking abt that then Yes you can use receiver rule in integration scenario in receiver tab...according to your condition you can configure multiple receivers in IS.
Monica
Edited by: monica bhosale on Aug 26, 2011 11:16 AM
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Markus,
Unfortunately, it is not possible. You can only use Receiver rule in Receiver determination. You may create a local rule by adding condition/s instead.
Regards,
Jenny
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
86 | |
10 | |
10 | |
9 | |
6 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.