on 08-24-2011 3:25 PM
Helllo to all community.
We have custom Planning Area-Planning book-Data view for some Capacity calculations.
Also we added some custom key figures with 001 shemantics (LC Time Series) and we use them to make and store different calculations in Planning Book.
Macro's working properly calculations saved in PB - its all ok.
But when I test created to this PA data source it shows zeros (0) for this added KF's some standard capacity KF's are ok. We are using 9ALORE aggregate.
Does anyone have any suggestions why I can't see any data from this custom KF's in a extractor check in RSA3?
Thanks a lot in advance!
Hello,
Have you assigned your TS key figure to the aggregate 9ALORE in /sapapo/msdp_admin 'assignments' tab?
Please also make sure that the TS key figures are correctly saved in liveCache. -- but not only calculated by macro.
Best Regards,
Ada
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Ada,
Yes, all custom KF's are correctly assigned to Aggregates.
Also I've checked LiveCache TS with following reports/transactions:
1./SAPAPO/TS_LCM_CONS_CHECK
2. /SAPAPO/TS_PAREA_INITIALIZE
3. /SAPAPO/TS_LCM_REORG_SNP
4. /SAPAPO/TSCONS
Everything is green i.e. ok
Any suggestions?
Best regards, Andrey.
Hi Andrey,
Is the data in the key figure calculated by default macro?
Please try remove or deactivate all macros in the default group, and then load the data.
Is the data there without default macros run?
If not, it means that the data caluclated by macro is not really saved in liveCache, thus no data could be extracted.
Best Regards,
Ada
User | Count |
---|---|
8 | |
4 | |
3 | |
2 | |
2 | |
1 | |
1 | |
1 | |
1 | |
1 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.