BDLS t-code Doubt after copying existing ECC to the new ECC

[Former Member]

Hi,

We are creating a new ECC client by copying other already exist ECC Client with SAP_ALL Profile. Both are at ECC 6.0. Source and Destination ECC have Development and Demo Server respectively.

Old ECC Client : ECDCLNT801

New ECC Client : PHDCLNT902 (Created by copying ECDCLNT801 with SAP_ALL Profile)

After Creation of Client , We run two BDLS t-code in PHDCLNT902.

Source : ECDCLNT801 and Target : PHDCLNT902 (On selecting Client Dependent and Independent Tables)

After done this I am getting the same GUID no in CRMPRLS table for both ECCs.

Is it fine having same GUID no. for PHDCLNT902 and ECDCLNT801 in CRMPRLS table as mentioned PHD 902 is the copy of ECD 801 with SAP_ALL profile , so the GUID should have different or the same?

Or have to delete that entry from PHD 902 and again need to re run *BDLS * to get the new GUID at PHD 902?

Kindly correct me, will give points.

Regards,

Pawan Keshwani

[laurent_burtaire · Accepted solution]

Hello Pawan,

Have a look at OSS notes below:

588701 - Change of the logical system name in R/3 Backend system

765018 - Problems with logical system during data exchange.

It will solve your problem.

Regards.

Laurent.

[Former Member · Accepted solution]

My Issue is resolved by deleting entries in CRMPRLS in ECC and again creation of new GUID by running R3AS in SRM.

Thanks for support.

Regards,

Pawan Keshwani