on 08-18-2011 8:20 AM
HI,
Yesterday some interfaces run in prod system under namespace http://sap.com/xi/APPL/Global2 from ECC with sender interface PurchaseOrderCreatedInformation. and all went to error with no receiver found as there is no config for these in ID.
I dont know how these interfaces trigered from ECC. How these can be stopped from triggered again?
With Regards,
Praveen.
Hi,
otherwise check whether the SWC SAP APPL 6.4 is used anywhere else also...
if not ask basis to remove the SWC from the system itself....
HTH
Rajesh
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You need to check which job in ECC system triggered this proxy.....ask the ECC developers not to trigger this job again till the time your ID is ready.
If you are looking for some setting to stop this then you can do some changes in the RFC destination so that message fails in ECC itself....may be you need to take permission of your supervisor to do so.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
It doesn't make sense to make these fail in the ECC. There may be other messages sent out that should go to the PI/XI!
Ask the consultants who are configuring the ECC. One of them must have activated the customizing that results in sending out the messages (usually based on a status change of the purchase order or other object in question).
Hi,
check in ECC for sender interface PurchaseOrderCreatedInformation, i think proxy genarated for this and some one executed proxy program.
take help from ABAPer ,he will help you .
Regards,
Raj
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
86 | |
10 | |
10 | |
9 | |
6 | |
6 | |
6 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.