Cannot see interface Mapping

[Former Member]

Hi

I want to read a message via the RFC adapter and send it over the xi channel.

Everythink in the design-time is set up. Once I configure the receiver determination, I cannot see the Interface Mapping.

Could you help me?? One business system is sending and receiving.

Regards,

Goekhan

[udo_martens]

Hi Gökhan,

if you dont can choose the IF mapping in the IF Determination then you configured assumedly sending Outboud IF and receiving Inbound IF wrong. Plz check your configuration again. I found that "error" as a good help to avoid wrong configurations.

Regards,

Udo

[Former Member]

Hi Udo

Thank you for you help.

I have made some changes in the message and interface and activated everything and performed cache refreshs.

Finally, I could see my interface mapping.

Puhh....