Goods Receipt generates inspection lot using inspection type 08

[Former Member]

Hi,

I have two plants A and B. I have set up my materials with an 08 inspection type plant B. Material transfers from plant A and B generate an inspection lot using inspection type 08 and inspection lot origin 08. This works perfectly.

However if I use a stock transfer between two storage locations within 1 plant, using stock transfer order, inspection lot is generated using inspection type 08 when GR is performed.

Is there a link between 08 inspection type and 101 movement

Regards

[Former Member · Accepted solution]

However if I use a stock transfer between two storage locations within 1 plant, using stock transfer order, inspection lot is generated using inspection type 08 when GR is performed.

Its true that whenever you do stock transfter between the storage locations in same plant ,system will create 08 inspection lot.

But this happens for goods mvt 301/311 when done by MB1b T code.

101 mvt is associated with 01/04 inspection type & not 08 when it comes to GR aginst order.

check the mvt type again....

[Former Member · Accepted solution]

Thank you for your feedback

In my case I am using VL31n to create an Inbound Delivery as one storage location is HU managed.

For example for plant B, I have storage locations X and Y. For transfers from X to Y using STO there is no issue. For transfers from Y to X (non HU to HU) an inspection lot is generated. Movement in Inbound delivery is 101.

[Former Member]

Yes ,101 & 08 are associated with each other for stock transfer order that is only when receipt indicator is "X" and mvt indicator is prchase order.

If you do not want this to haapen then

copy mvt type 101 as Z01 & for this mvt type deactivate QM in

QCC3->inspection lot creation->Inspect for goods mvt->Deactivate Quality Inspection for a Movement Type>Z01-->deactivate

Use this mvt type when you are tranferring material from storage location to storage Location.

This will not create any inspection lot.

Edited by: Sujit Gujar on Aug 4, 2011 1:09 PM

[Former Member]

Yes there is definitely a strong relation between movement type and inspection lot origin ( Not inspection type).

SPRO -> Quality Management -> Quality Inspection -> Inspection Lot Creation -> Inspection for goods movements -> Movement type/ update control/ inspection lot origin.... there select the 101 and check the last field of internal control, its inspection lot origin. You will find 01, 04 and 08 insp lot origins are defined there. Note that it is marked as not changeable, so that's SAP defined rules for movement type/lot origin.