on 08-01-2011 3:42 PM
Hello friends,
I want to configure auto logout parameter in NW 7.3 portal if a user is waiting idle for 2 minutes. User should be loging off after 2 minutes if he does not do anything in his session. We were changing it in config tool for previous version of NW portal. But, I did not find in NW 7.3 NWA?
Best Regards,
Sinan Isik
Hi,
Set this parameter value accordingly: icm/keep_alive_timeout
Regards,
Vamshi.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi All,
I also have the same requirement, so is it possible to auto-logout a user by just changing some parameter in the SAP NETWEAVER PORTAL 7.3.
If yes then please mention the name of the parameter and the path to the parameter.
Thanks in Advance,
Rohit Gupta
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
We have no abap stack. Only we have java stack. Could you please tell me how I can change this autologout parameter in NW 7.3 Enterprise portal (java only)
Best Regards,
Sinan.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Please look the following link.Hope this will help you..
https://wiki.sdn.sap.com/wiki/display/EP/EPSnippet-Portaluseridletimeoutforlogoff-custom+javascript
/people/santhosh.lingaraju/blog/2008/11/05/portal-user-idle-timeout-using-dialog-windows--client-side-solution
Regards
Bhuban
RKFL
HI,
Please check the below link for setting the parmeter for JAVA system.
http://help.sap.com/saphelp_nw72/helpdata/en/48/88b52977323cb8e10000000a42189d/content.htm
It will be helpful for you .
Regards
Pranay
Hello Sinan,
I got a consolidated troubleshooting guide for NW 7.3 PI and following is the link to the pdf:
In that, it has been mentioned to increase the value of the Max wait-time for HTTP response parameter for ServicesRegistrySiPort.
In order to do this, access NWA (http://[host]:[port]/nwa) and navigate to SOA Application and Scenario Communication Single Service Administration. On the Consumer Proxies tab, select ServicesRegistrySi. On the Configuration tab, select ServicesRegistrySiPort. On the Transport Settings tab, increase the value of the Max wait-time for HTTP response field and save the changes.
Hope this is helpful.
Hope this helps
http://www.ameyablog.com/netweaver/netweaver-portal/4-ways-to-configure-portal-time-out-parameter/
Cheers !
Manish
User | Count |
---|---|
84 | |
10 | |
9 | |
8 | |
6 | |
6 | |
6 | |
5 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.