on 07-29-2011 3:32 PM
Dears
1.in my QA32 scree for a raw material three inspection lot still there with status REL SKIP SPRQ QLCH
And i try to make auto UD form T code QA10
I enter plant
inspection type
select Automatic Usage Decision for Skipped Inspection Lots
But nothing was happen sytem response with a information No entries found
Please tell me why system behave like this
2.For using DMR is it compulsory with inspection point
Faisal
Edited by: Muhamed Faisal on Jul 30, 2011 2:32 AM
1. There is a wait time for skip that has to be reached. Check you config settigns in the QM plant settings. Make sure that is reached.
2. DMR is not a requirement for inspection points.
FF
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Most probably any of your characteristics in the plan is marked as required. you can not do collective UD with required MIC.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
1.in my QA32 scree for a raw material three inspection lot still there with status REL SKIP SPRQ QLCH
I do not think it it has to do anything with Skip duration as you are processing UD manually.
Just check following things like
1.Are char "Required" .Try to put optional.( control indicator of all MIC)
2.Check selection criteria.Check every possibility.
3.What is inspection type ,if its 04 then use QA41
2.For using DMR is it compulsory with inspection point
No relation between Inspection point & DMR.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
99 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.