on 07-26-2011 8:36 AM
Hi Gurus,
I have installed Solution Manager 7.0 EHP1. I want to perform Initial configuration, Basic Configuration and then configure mopz in it.
Following is the list of the components of my solman
SAP_BASIS 701 0002 SAPKB70102
SAP_ABA 701 0002 SAPKB70102
ST-PI 2008_1_700 0000
PI_BASIS 701 0002 SAPK-70102INPIBASIS
SAP_BW 701 0002 SAPKW70102
CRMUIF 500 001 SAPK-50001INCRMUIF
SAP_AP 700 0012 SAPKNA7012
BBPCRM 500 0012 SAPKU50012
CPRXRPM 400 0013 SAPK-40013INCPRXRPM
BI_CONT 704 0001 SAPK-70401INBICONT
ST 400 0018 SAPKITL428
ST-A/PI 01L_CRM570 0000
ST-ICO 150_700 0017 SAPK-1507HINSTPL
ST-SER 701_2008_2 0000
- Do I need to perform support package upgrade before initial and basic configuration and then configure mopz.
- If yes to which sp level shall I upgrade, will sps 26 be sufficient?
Regards,
Varun Satyarthi
Edited by: Basis Admin on Jul 26, 2011 9:36 AM
hello ,
If you have issues with Maintenance Optimizer because you haven't configured the basic functions needed, you can always use the http://service.sap.com/sp-stacks -> Support Package and side effect report download tool in the marketplace. Solution Manager stacks can be downloaded from there, once you put the stack in your download basket you need to approve it with a message under SV-SMG-MAI-APR.
Best regards,
Miguel Ariñ
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Miguel,
Thank you for information which I feel is important.
I am currently downloading sps26 via download manager. I used the same procedure to get the approval from SAP that you specified.
I mainly wanted the answer for the question " Is it necessary to upgrade solman 7.01 before configuring it or we can do configuration with out upgrading it ?"
Thank You,
Varun Satyarthi
Hi,
As we said it is not mandatory to upgrade. But it is always recommended to have system on latest stack. As far as your question is concerned, you can do the configuration after or before upgrade. But reason why I asked to do upgrade before configuration is because it might possible that after upgrade you will face some issues, if you will do config after upgrade then you can test the same as well. So, you can avoid your efforts twice.
Thanks
Sunny
Hi,
You should upgrade it to n-1 level.
Thanks
Sunny
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Sunny,
Thanks for reply
So as you said I should upgrade to n-1 level i.e current available stack is 27 so sps 26 will do.
You didnt answer my first question.
Do i need to do upgradation before initial, basic configuration and other activities like mopz configuration
Thanks and regards,
Varun Satyarthi
User | Count |
---|---|
87 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.