cancel
Showing results for 
Search instead for 
Did you mean: 

No sampling procedure found for sample determination

Former Member
0 Kudos

Hi,

There is inspection lot with Status CRTD. When I trying to calculate sample facing error " No sampling procedure found for sample determination".

But inspection plan assigned to inspection lot have sampling procedure for all MIC's.

So do system throwing this error.

Regards,

Accepted Solutions (0)

Answers (1)

Answers (1)

former_member42743
Active Contributor
0 Kudos

Double check the inspection plan by accessing it via QA02. This ensures you are checking the actual plan, not the one you think it is or that is currrently assigned.

Also, check the individual sampling procedures and make sure the are correct for the plan. Sometimes changes are made to plans that require a change to the sampling procedures. If they weren't changed, or one was missed you can have this error. Go into the plan and reselect the sampling procedures to double check them.

Then goto QA02 and try to reperform the sample calculation. See if it gives you any errors.

FF

Former Member
0 Kudos

Hi,

Thanks for ur reply.

I have properly checked inspection plan & found every MIC's with proper sampling procedure. And same inspection plan has assigned to inspection lot.

Former Member
0 Kudos

Check theQM view of inspection type-->have you ticked on manual sampling ,percentage sample etc ........if yes the remove it..

Also go to QA02 >sample tab->click on sample. "What error you are getting here?? "

Former Member
0 Kudos

Hi Sujit,

There is no manual sampling,percentage sample etc in inspection type. There is tick for material specification.

When click on sample tab in QA02 facing below error.

No sampling procedure found for sample determination

Message no. QD256

Diagnosis

In sample or test equipment management, the system has to find a sampling procedure for every inspection characteristic. This can either be specified for the inspection characteristic in the inspection plan or in Customizing as a default value.

In this case, no sampling procedure has been specified either in the inspection plan or Customizing.

System Response

As a result, the sample determination could not be executed for the inspection lot.

Procedure

Assign a sampling procedure to every inspection characteristic in the inspection plan, or

Define default sampling procedures in Customizing for sample management and test equipment management.

Create the inspection lot again, or carry out the sample determination using the "Change inspection lot" transaction for the incomplete inspection lot.