IDoc Adapter Logical System Empty

[former_member191528]

Hello All,

For one of our scenarios for Reciver IDoc adapters we are getting the error "Receiver service cannot be converted into an ALE logical system ". On further investigation it seems the logical system stays on editing the Adapter Specific Message attributes option & even after clicking the Compare with SLD Option. Can you please assist us with this issue ? Also sldcheck runs fine but sldapicust gives an error CIM_ERR_FAILED. We recently upgraded our sld and we believe this might be the issue.

Thanks,

Kiran

[former_member854360 · Accepted solution]

Please check in SLD whether logical system name corresponding to your Business system name is maintained or not.

[former_member191528 · Accepted solution]

Hi Debashish & Veera,

The issue has been resolved. When our SLD was migrated to a newer version 1 month ago back our logical system names got cleared. We did not face this issue until yesturday since the logical system names were still cached with the business system. Yesturday a newer IDoc scenario was imported in production and which caused the business system cache to be refeshed and it started pulling the new empty logical system name causing the scenarios to fail.

Thanks,

Kiran

[Former Member]

Hi,

As Debashish said check SLD to see is your business system/Service maintined with Logical System and then from ID you do Compare with SLD Option. It may take you 2 or 3 minutes. If LS name maintaned properly that should be reflected into ID.

Cheers

Veera