Create Inboud Delivery

[Former Member]

During the Create Inboud Delivery (VL31N)

After I had put the storage location in this transaction, the system shows the message u201CMaterial 10018978 1100 cannot be used in inbound delivery because QM is activeu201D. This storage Location is controlled by WM , this is a ROH Material and We need the QM actived but it was not possible to create inboud. What I have to configure in WM to accept this process ?

Marcos

[christian_rosa · Accepted solution]

Hi Marcos,

I have understood from the item 3 from Ramana's reply that you may perform goods receipt from MIGO for example right over the Purchase Order. It seems then VL31/VL31N cannot be used indeed.

BR,

Christian

[Former Member · Accepted solution]

Dear Christian

In fact, in our process we need to generate a inbound delivery before Migo, because at that moment we haven´t the material to receive yet .

Thanks

Marcos.

[Former Member]

Hi Marcos,

************************************************************************

The error message is basically correct because the use of a QM-relevant

material in inbound deliveries is currently only possible on a

restricted basis.

1. If the item of an inbound delivery is relevant for a HU-managed

storage location, a QM-relevant material can also be used. If the

"Inspection for HU" indicator is set in the relevant inspection type

(01 Goods receipt inspection for order), an inspection lot is

created when handling units are created in the inbound delivery. If

this indicator is not set, no inspection lot is created. An

inspection lot is not created either in the later goods receipt

posting for the inbound delivery.

2. If the item of an inbound delivery is relevant for a

decentrally-managed storage location, system behavior is identical

to the one above with active handling unit management. This behavior

is produced by the attached correction. To date, the above error

message L9528 appeared in such a constellation.

3. If an item of an inbound delivery is relevant for an integrated WM

management storage location, the system still generates error

message L9528 since this process is not currently supported. In this

case, you cannot carry out your goods receipt processing via an

inbound delivery but can only carry out it via a goods receipt

posting to the purchase order.

***********************************************************************

Kind regards,

Ramana

[Former Member]

Dear Ramana

I checked this forum that I can not use the VL31 for this case without applying the note 491500. Is that right?

Thanks

Marcos

[Former Member]

This message was moderated.