Message no. /SAPAPO/SNP105

[former_member182449]

Dear All,

Please i need your support regarding to this issue:

I maintain my demand 1000 PC in Total Forcast key figure and transfer it to SNP

I got this errpr message "Message no. /SAPAPO/SNP105" & " conversion from PC to S for Product P-100 is not possible "

Thanks

Rami

[Former Member]

Hi,

Check UoM is consistent in DP and SNP planning area. Also Base UoM is consistent in product master and SNP Planning area. If Base UoM is different than SNP Planning area than make sure you have conversion/relation maintained in Units of measure tab in product master.

Regards,

Harshil Desai

[former_member182449]

Dear Harshil ,

Thanks for your response

In product master UOM is maintained as PC and also the same in Planning area PC

Thanks

Rami

[Former Member]

Hi,

In the product master check if there conversion factor defined for PC to S.( OR ST)

Thanks,

nandha

[former_member182449]

Dear ,

Why he ask for this conversion factor from PC to S ?

Regards

Rami

[former_member182449]

Dear Harshil ,

I mean what's the reson for conversion from PC to S ?

Regards

Rami