on 06-16-2011 9:12 AM
Dear all experts,
I am new in PP. After i run MRP and i go to MD04 . Noticed that, 1 message is shown as below
62: Scheduling: Master data inconsistent
I have checked Routing and BOM and they are correct.
I am using ECC 6
Any solution on this issue?
Thank you.
Dear cijelew,
I dont think there is problem with configuration setting,but it's with
1. BOM validity date,BOM status.
2.Check if any change numbers are used with release key and ensure the release key is set.
3.Routing status,usage,validity and also
check if BOM selection method is value 2 or 3(production version--->so check whether production version has been created
properly,lot size,validity date,check where you have assigned the routing group and group counter whether is it against
detailed planning,rate based planning or rough cut planning).This routing assignment should be against the correct planning
level as per the configuraion setting made in OPU5,for the selection ID.
Check and revert.
Regards
Mangalraj.S
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Please check the scheduling formula in Work center
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear Experts,
Thank you for your suppor. It should be OPU3.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
You can try to check in OPPQ. in Sell:rate plng and SellD:roughPlng.
Hope can solve your problem
Pann
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
99 | |
11 | |
11 | |
6 | |
6 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.