on 06-15-2011 10:28 AM
hi,
simple question.
Where can i find the username of a cancelled message in the RWB (adapter engine monitor) ?
I can´t find the username in the audit log, message log or somewhere else.
The audit log is only showing the entry: Admin action: The message was successfully set to status failed.
I ´ve searched the nwa logs without success.
any ideas ?
Go to SE16 transaction, open the table contents of the SXMSPMAST table. Search for the message ID and look at the field ADMINUSER. This should contain the responsible for the last admin action on the message (in this case, cancelling it).
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Yes, it logs only when the message is cancelled on the ABAP stack.
However, I checked here on a 7.1 system and I was able to see the following entry on the Audit Log:
"Trying to fail the message because of administrative action of user "xxxxx"." Can you review all the entries of the cancelled message on the audit log?
Therefore please apply the patches recommended on the note below.
> 1401840 - User name in Audit Log entries for administrative actions
"Symptom
When a user performs administrative actions on XI messages of the
Adapter Engine, the user name is not included in the Audit Log entries.
It's afterwards impossible to determine the user who canceled or retried
an XI message."
User | Count |
---|---|
84 | |
10 | |
10 | |
9 | |
7 | |
6 | |
5 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.