problem with TCODE PK02 with the warehouse number field.
Hello folks,
I have created a control cycle in the TCODE PK01. When I tried to change it it is not displaying the warehouse number that I have used while saving. Also here it is showing the warehouse number as a mandatory field.
I have input the warehouse number in the PK02 TCODE and saved. I am able to see the warehouse number value updated in the table also. But again if I try to enter the PK02 TCODE , it is displaying empty warehouse number and showing as a mandatory field.
Also in TCODE PK03 tcode , I am not able to see the warehouse number field I have saved.
Can anyone address on the below issues?:
1. how to configure the PK02 warehouse number mandatory field settings and
2. Populating the warehouse number field in the PK02 and PK03.
Thanks,
Ramineni.
<< Moderator message - You have a better chance of getting answers to a question if you flag your thread as a question rather than removing the flag. >>
Edited by: Rob Burbank on Jun 14, 2011 9:57 AM