Unable to activate Transfer Rule

[former_member1213279]

Hello Experts,

I am not able to activate Transfer Rule in my System ( BW 3.0).

I have written one routine and then when I am trying to activate I am getting below error messageu201D

Object 0NOTIFICATN_ATTR object version not found in table.

My Data Source name is 0NOTIFICATN_ATTR.

I have also tried to activate by using RS_TRANSTRU_ACTIVATE_ALL but still no luck.

I also checked table TADIR and I can see entry over there.

Regards,

Pankaj Naik.

[Former Member]

Hi Pankaj,

Try to activate the transfer rules by executing the SE38 report - RS_TRANSTRU_ACTIVATE_ALL.

Also check the note - 884385 , For 'RSAR' errors while activating update and transfer rules.

Regards,

Lokesh

[former_member1213279]

Hello Experts,

My Data source , Info Object both are active, i have checked routine also for systax error , thats is also fine.

Regards,

Pankaj Naik

[Former Member]

Hi Pankaj,

Make sure the syantax is correct for the routine written in the transfer rules. Also make sure that the DataTarget is also active. I hope you have activated the DS after replication. Once everything is fine then try activating.

Regards,

Pavan

[former_member1213279]

I have replicated data source again but still no luck.

[Former Member]

Have you tried to replicate the DS once again? failing that I might look at SE14 and try to straighten it out directly in the dictionary. But I would first replicate and try to activate once again.

HTH,

Pat