RSA1 Data source has old system entry even after BDLS

[former_member325638]

Hi Experts,

Our BW system is on SAP_BW 701. Recently Our ECC system got replaced by a new upgraded system. So I ran BDLS from old system to new system. It went successfully and data sources were active.

Later we found there is one data source that had two entires. One with old logical system and one with new logical system.Could anyone please advise how I can find why old logical system name entry still appears there even after BDLS.

Thanks,

Varun

[andreipg]

There might be a better solution to this, but you need to go and manually delete DataSource entries pointing to the old source system from table RSOLTPSOURCE in BW.

[former_member325638]

Hi,

We checked that BDLS run has been fine and there were no errors or warnings. Also all the data sources ahve a soirce system as the new logical system name. But for many data sources; old logical system name's entry is still there. Old system is now not active but we are not getting how we got the old logical system names entries as well alon with new ones. When we try to manually delete those data source entries by right clicking on that; it gives an 'X Fatal error' and does not delete. Looks like its not getting deleted because the old logical system name is not active now. Please advise how can we get rid of these data source entries along with old logical system name and we do not want to re run BDLS.

Thanks,

Varun

[Brindavan_M]

Hi Varun,

How you have run the BDLS.. you have run the BDLS A* to a* for each alphabet. Then only completed naming convention will happen. Running in foreground with normal it will finish immediately withlog,but mostly it wont convert all. your ECC system might be integrated  with many system like biw,like PI etc.. so you need run those.

Thanks & Regards,

Brindavan