Changing mapping values of car model

[Former Member]

Hi,

We have a scenario to change the mapping of the car models in infotype 0017. The present scenario is as follows

<=1400 cc the valid value is 2 (PA0017- KZPMF).

I need to change the configuration as <= 1600cc .

I tried in table V_T5GC2, but it is for adding a new car model.

Where to configure this?

Thanks in advance,

Aravind

[former_member131723 · Accepted solution]

Hello Aravind

The vehicle types are maintained in T706E and the vehicle classes are maintained in T706W so it is here you need to ammend the entry for engine size.

If you can choose a specific combination of vehicle type and vehicle classe ONLY depends on table T706F: if you

have maintained a reimbursment rate for the specific chosen combination.

Hope this helps!

Kind regards

Sally

[Former Member · Accepted solution]

Hi Sally,

Thanks for your reply.

I need to change the mapping criteria. I need to find the table where mapping values and conditions are maintained or is there

any other way to do this?

The scenario is Instead of mapping <=1400cc to 2, i need to map <=1600cc to 2.

Thanks in advance,

Aravind.

[former_member131723 · Accepted solution]

Hi there

Yes, you can change the vehicle text type in the table I mentioned - check V_T706W and here you can specify the new CC size.. infotype 17 pulls the information for the vehicle type (and thereby the CC) from these tables - V_T706W and V_T706E

If you want to change the rates for this car type then you can do it here - V_T706F, you may also want to check V_T706E.

cheers

Sally