The data from the InfoProvider 0COSTELMNT involved could

[Former Member]

hi all

i am loaded data into the cost element master data (attr) but my issue data is loaded successfully but under requets tab there is no requests but data is there in cost element .and when i go for diplaying data i have one message regarding this cost element

that is

The data from the InfoProvider 0COSTELMNT involved could not be checked.

here can anybody find out the solution pleaseeeeee

[Former Member · Accepted solution]

Hi there,

That message appears because you don't have requests under the InfoProvider 0costelmnt.

But that's no problem with that. The data is still loaded and should be also activated the change run under RSATTR transaction and you can still display its data like you're doing.

Ignore that. The data is still loaded and can be checked.

Regards,

Diogo.

[Former Member · Accepted solution]

ok thank you

[Former Member]

Hi,

you do not see requests because it might not have been defined as an infoprovider and loaded using flexible update. It is loaded using direct update of master data by defining it as an infosource. Check the master data table /bi0/pcostelmnt. It would have data.

Hope you have activated the master data/carried the attr change run.

[Former Member]

i defined it as infoprovider and here is no chance to load data using direct update because i am using bi 7.0 as of my knowledge in bi 7.0 direct and flexible update is not there.