Info package sucessful but 0 records transferred

[Former Member]

hi

we are doing a full load from r/3 when we requested for data in Infopackage , in the monitor of ip it is showing successful but 0 of 0 records are transferred. But when we check for in RSA3 it is showin 300 record.

In IP monitor it is shwing this message

diagnosis:

In this case, the corresponding table in the source system does not

contain any data.

System Response

Info IDoc received with status 8.

Procedure

[Former Member]

Hi,

Did u recently made any changes in extractor? if yes replicate it first in your bw system. Also check whether u are connected to same source system for extraction in which u are carrying ur testing (RSA3).

Regards:

Jitendra

[Former Member]

it is a crm opportunity header data source 0CRM_OPPT_H

we dont have any selections on it...

[Former Member]

Hello,

Check this: Your data load is probably based upon Delta, for which there may not be any delta records, however your RSA3 test is most likely a Full load.

Perhaps that is the case.

I hope that helps,

Nick

[Former Member]

Hi,

Please let us know wht type of extraction is it, does this extraction require any Setup tables filling??

If so pls fill the Setup tables and execute your Infopackage.

Regards,

Vishnu.

[Former Member]

Hi

As adviced above first see if extractors are workingfine using RSA3 in ECC.

if u dont see any data there check source table if there is any data for your selection.

you may have to check your selection parameters... even capital small letters or missing zeros to left in filter values might be causing this problem.

Regards

Sudeep

[Former Member]

Hi,

While executing the infopackage check the data selection that if there is any selection exist there.Also check some time routine is written fiscalyear(eg routine to fetch data only for curr week) in data selection .Just cross check that also.

Thanks,

Deepak

[Former Member]

Hi,

Please check the selections in the info package. It seems for the given selection there is no data in the source.

Also check RSA3 in R/3 with selections same as the info pack.

Regards,

Shyam.

[Former Member]

Hi,

In RSA3 do u give any selection? Try giving same in BW