data not getting extracted in RSA3

[Former Member]

Hi All,

I'm trying to extract data in RSA3 but 0 records are getting selected. The datasource is build on 2 tables and the tables have data. In R/3 development data was getting extracted and the same has been transported to R/3 Quality. But now in quality no data is getting extracted though there is data in table. Please provide suggestions.

Thanks in advance,

Sananda

[Former Member]

Hi,

First check whether the two tables on which the datastore is built have data .See the contents of both the tables .

then check the join conditions if any , whether the data in tables meet the join conditions .

[Former Member]

Hi,

In RSA3, have you selected full(F) in Update mode field ? Have you specified some filter values, ensure that you have preceding zeroes filled, some times that creates problem. Try extracting in de-bug mode and take any one data which according to logic should get displayed and analyze along that line.

Regards

Raj Rai

[Former Member]

Hi,

Please check whether you have filled the setup table for the data source which your are trying to extract from RSA3

[Former Member]

Hi,

You will not get the data if,

1.If you do not fill the set up table for (LIS data sources)

2.If you put some filter which is not matching the key in source.

Thanks and Regards,

MuraliManohar.

[Former Member]

hi,

Check if this is an authorization related issue.

regards,

Arvind.