on 05-18-2011 2:22 PM
On jump from a BI report to another (from any characteristic or key figure), following warning message comes up in the second report "Source selection for 0FISCPER incompatible for target selection". This is user specific, not all users are getting this message. It is not an authorization issue. Please provide your thoughafter and soughtafter suggestions.
Edited by: Suprabhat99 on May 18, 2011 3:23 PM
Hi Suprabhat,
Please check if all the Query restrictions like variables,selection options,interval,hierarchy etc is same for Source and Target Query for that paticular char - 0FISCPER.
Then Incase there is no discrepancy in above types then please check SAP note 1265027:
Also below forum should help resolve your issue :
Regards,
Akanksha
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hello,
If the results that are transferred on the jump are correct then this message can be ignored. There is most likely a small discrepancy between sender and receiver.
As to why only some users get the message I would guess that some have their messages suppressed in BEx. You can suppress the warning message by "Business Explorer" -> "Settings" -> "Suppress warnings from server" in bex analyzer.
Regards,
Michael
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
88 | |
10 | |
10 | |
9 | |
7 | |
7 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.