WWI SERVICE not starting

[Former Member]

I am trying to connect a new ECC enviornment to an existing WWI GLM server which is already connected to our SAP Dev. server .I have created RFC Connection for the EH&S Management Service and WWI generation server. My RFC connection for EH&S

Management Service is OK. when i log in CGSADM in new SAP server i can see the WWI server .

.

Nextstep i create the WWI generation server. It create the service and i seethe entry added in SAPRFC.INI also but when i try to start the service i get the message

===============================================================

S:c$:137 Error: Unable to start service 'WWGLM**_SERV_S 01_01' due to

following reason. Error = The servic e did not respond to the start or

control request in a timely fashion. , Internal = StartService

Message no. c$137

================================================================

When i try to start from windows service i get this message

===========================================================

Couldnot start service. Error 1053 the service didnot respond.

===========================================================

Can any one provide some input what the issue .Why the new service is not getting started.

[Former Member]

I've installed new software EHSWWI32_42-20010357 on my Windows Server 2012R2.

It Install service viz(EH&S Administration Management Server) on my computer which in turn run ehsManSrv.exe.

When I Start this service it gives following error 1053

"The service did not respond to the start or control request in a timely fashion"

If you have handle similar issue,  Please provide your guidance

Hiren Shah

[former_member198518]

Hello Hiren,

Please check the below KBA, it should be helpful:

2199434 - EH&S Administration Management Service does not start

Best Regards,

Camila Zilles

[Former Member]

Hey.

I am facing the same problem.

Did you get the solution?
If you get it please post it here.
Thanks n regards.

Mihir

[former_member212503]

I am getting differ error . S:c$:137 Error : UNable to restart service ' WWI_************" due to following reason . Error= The service did not start due to a logon failure ., Internal = StartService

[christoph_bergemann]

Dear Krishna

check:

You should not use the saem WWi Server for two SAP Systems (it is possible but "tricky". If you use the saem Server. Do not mix. That means: the Server should not be used for GLM purpuses for one SAP System and for e.g. MSDS generartion purposes on different SAP service

C.B

PS: Read the cookbook ! Check always the moszt recent Version on Marketplace. Don't omit one step, Pay Attention on Windows (user accounts etc.)