# Calculated Characteristic in Single Result Recording with Insp. Points

Good morning,

i have the following situation:

4 Master inspection characteristics with single results recording for inspection points with also calculation with formula. So, for example, MIC A = (B - C) / D.

The system, calculating the value of MIC A, takes into consideration the average value of n measures for each inspection point of MICs B, C and D. So, for each inspection point, the system calculates value of A in the following way:

A = (B Average Value - C Average Value) / D Average Value.

In yuor opinion it will be possible to have the value of MIC A calculated for each measure of the inspection point and not only for the average value of the inspection point? I think that the standard system does not support that functionality, and it is necessary a custom report, but i don't know if there's some Function module or Bapi that could make easier this kind of calcutation.

Thanks in advance.

##### Anand Rao replied

Hi,

Try this if works for you.

Define MIC A calculated characteristic in QS21.

While creating your inspection plan let us say your sequence of MICs is as follow

MIC 10 = B

MIC 20 = C

MIC 30 = D

MIC 40 = A

Your formula for MIC 40 i.e. for MIC A should be like this.

**(A00010-A00020)/(A00030)**

A = (B Measured Value - C Measured Value) / (D Measured Value)

You must be using C0 in formula. C0 is for average and A0 for measured value.

Regards.

Anand Rao