Skip to Content

Archived discussions are read-only. Learn more about SAP Q&A

Changing specification during result recording.

This question is answered

Hello,

Is there any functionality in result recording (QE51N) which allows you to change specification for quantitative inspection characteristic?

Example:

specification 5,0 .. 6,0. You record result 4,9 and change specification to 4,9 .. 5.0 which causes that valuation of inspection characteristic is accepted

Best Regards

Andrzej

May 18, 2011 at 17:14 PM
0 Likes
Correct Answer
replied
May 16, 2011 at 13:58 PM

Hi,

To address this scenario:

1. First change the specification limits by going in to QP02

2. Go to QA02 and cancel sample (there is icon at top) and save

3. Now, assign the changed specification to this inspn lot

4. Now you can record results comfortably..

However, doing this everytime when the material is Out of Specs is rather going against the very principle of Quality Management !!

Regards,

Krishna

0 Likes 0 View this answer in context
Not what you were looking for? View more on this topic or Ask a question

8 replies