No "Inspection lot stock" tab in QA11

[Former Member]

Hi,

Quality lot gets created for each Goods Receipt for material with Quality management active. For particular raw material we found that for last Goods receipt the quality lot got created as usual. But in QA11 we found that there is no "Inspection lot stock" tab whereas for the second last Goods receipt for the same material there is "Inspection lot stock".

What would be the reason?

With Best Regards,

Rajkumar

[Former Member]

This message was moderated.

[former_member42743]

Any chance this got created via a source inspection? Did you verify the quantities are in the material document that created the lot? Was the batch number assigned?

Is there a SKIP status on the inspection lot in question?

FF

[former_member1362664]

Hi..

Please check the status of inspection lot it may be cancel or block.

Regards

Vivek

Edited by: vivekrastogi on Jun 22, 2011 2:20 PM

[tanuj_parikh]

Hi,

Please refer: [].

QM does not suppoort Stock Posting for Special Stock like B, K.

Regards,

[Former Member]

In QM view->inspection type->check "Control InsLot" -->what it is ?