on 04-29-2011 6:06 AM
iam using QA16 for quality inspection .
Iam given material doc no in QA16,but iam not getting inspection lots for UD(usage decession).its comming empty screen in QA16.
iam using multiple UD at a time.
Dear check this below points.
1. Check if Material Master Auto usage decision has been checked.
2.All characteristics should be optional if not make all the char as "Optional " through control indicator This can be done for next lots only.
3.All chracteristics must be calculated and status should be 5 completed and no defect recording done.
4. Check mic indicator activated in material master and you have to do RR for this inspection lot or u can force fully complete all MICs and male IL status INSP and check again in QA16
5.Did you selected releavant UD selected set for inspection lot in QA16.
Cheers
KK
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Make sure that all the MIC's used in all Inspection lot are "optional' & not " required" .............in control indicator.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Ensure that you have completed result recording up to status 5 for all MICs in inspection lot. Then only it will be reflected in QA16.
Regards,
Anand Rao
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
102 | |
12 | |
11 | |
6 | |
5 | |
4 | |
4 | |
3 | |
3 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.