cancel
Showing results for 
Search instead for 
Did you mean: 

connect WMS to MM (stock already exists)

Former Member
0 Kudos

Hellow!

We have stocks in plant and storage location level. WMS is not connectet to this plant + sttorage loc.

Now I need to activate WMS (connect warehouse number to plant and st loc). How could I put initial stoch into WMS system whithout MM movement (stock already in MM )

Andrey Garshin.

Accepted Solutions (0)

Answers (4)

Answers (4)

Former Member
0 Kudos

Andrey

The simple answer is that you cannot do this

You must (as one colleauge as already stated) create a new St Loc and move ALL of the stock in to there and the activate WM in the existing st loc and then do a NB1B movement 311 which will put the stock in to 921 Transfer and then create TO's to move the stock to the correct Bins

I hope that this helps

Frenchy

christian_rosa
Employee
Employee
0 Kudos

Hello People,

kindly refer to the following thread below as well:

Best Regards,

Christian Rosa

christian_rosa
Employee
Employee
0 Kudos

Hello Andrey,

Is the location HU managed as well ? If not you can make use of LX23 transaction which will give you a comparison of what is in MM-IM and what is in LE-WM. Then you can try to clear the differences by flagging clear flag.

Take a look in the details of what LX23 does firstly as per SAP note below:

535043 - Stock comparison with LX23: Difference between WM and IM

+"The stock comparison report first reads all IM stocks and all special stocks. In the second step the WM stocks are read and summed up. If a difference then results when a comparison is carried out between the two internal tables, the individual stocks are listed and the difference calculated. A comparison is only carried out if you select the 'Clear differences' check box. The program then creates a batch input session for Transaction MI10. An automatic physical inventory is carried out

during the processing of the BI session in the inventory management that adjusts the IM stocks to the WM stocks.

If the stock situation is that the stocks in the inventory management are correct and the WM stocks are incorrect, then this situation can only be corrected using standard means by the differences being cleared in a first step, that is the IM stocks are adjusted to the WM stock, and in a second step in the WM the stocks being corrected by physical inventory count."+

Best Regards,

Christian Rosa

Former Member
0 Kudos

Hi,

For your requirement belowis th standard process

1. Create a new Sloc for plant (non-wm)

2. Transfer all stock to new Sloc

3. activate WM for your required plant/sloc

4.Transfer stock from new sloc(non-wm) to sloc(wm-activated)

5.Create T.O to move stock into WM sloc

Hope this helps you..

Rgds,

Kris.