on 04-14-2011 2:40 PM
Hi Guys,
We are doing some testing on a new interface where IDOCs are sent to XI. On R/3 in We02 the idocs show successful but it's not going to XI. Where do I check on R/3 where (which XI system) the IDOCs are setup to go?
Thanks,
Jan
Hello,
Check this Analysis guide
http://help.sap.com/saphelp_nw04/helpdata/en/6a/e6194119d8f323e10000000a155106/frameset.htm
Regards
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
You can find them in SM58 and there are few reasons why it occur
1) Message Overflow in PI
2) If an idoc is modified and the metadata of the idoc in ECC and PI doesnt match then the idoc ll not travel to PI
3)if the idoc is reimported in PI but the metadata is not deleted in IDX2 before importing.
I hope ur problem is solved and Sorry Experts if i m nt right.
Regards
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Jan,
look to the port entry, open it and control the destination. Check the destination in SM59.
Regards,
Udo
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
check transaction SM58 in ERP. See if there is any error over there.
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
84 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
4 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.