Different UoM for different KFs in the same SNP planning book

[Former Member]

Hi Experts,

The situation is- the SNP planning area is the copy of standard 9ASNP01 planning area, the planning area UoM is in TO. There are 4 products, whose UoMs are maintained in BBL.

When I load the products and the locations in the SNP planning book, and do 'Details all' in the header filter for product and location, the KFs are shown in TO for the total value(s) and in BBL for individual values of individual products.

Is this a standard behavior? I understand that we can 'set' the UoM in the planning book explicitly.

Waiting for valuable reverts.

Regards

Manotosh

[Former Member · Accepted solution]

Did u check the 'UofM from Product Master' field during Planning book definition??Have a look in the planning book settings to see if this field has been set. This field should be in 'key figure attributes' tab of Planning book definition/change window.

Regards,

Shiv

[Former Member · Accepted solution]

Hi All,

the issue is resolved. It is a standard SAP behavior. SAP Note 817446 talks about it in detail.

Regards

Manotosh