Calculate Master Inspection Characterstic

[former_member1362664]

Hello SAP GURU's

The business requirement is there are 10 MIC's in an operation and another one MIC is there which is called Total defects.

And in this one MIC result should be count of recorded MIC in those out of ten.

I maintain this one MIC as a calculated MIC and defining a formula in inspection plan e.g. A00010+A00020.

Two issue are coming

One is complete formula is not written as this is getting too lone as ten MIC's are there.

IInd is at the time of result recording despite of result recorded of all 10 MIC's when we click on calculate calculated characteristic system giving the error " Not all calculation input characs. in the formula have been valuated".

Please reply ASAP....

[Former Member · Accepted solution]

Can you not divide these char into group of 5 & then add these two groups.........

means first 5 char can be added to 6th char & 7th to 11th can be added to 12th

ten add 6th & 12th to get 13th char

This is just suggestion !!

[former_member1362664 · Accepted solution]

Thanks sir for your suggestion.

Yes it can be done.

But IInd issue is still alive that at the time of result recording despite of result recorded of all 10 MIC's when we click on calculate calculated characteristic system giving the error " Not all calculation input characs. in the formula have been valuated".

Please reply soon..

[Former Member · Accepted solution]

1.Check all control indicators........like all should have fixed scope & number of readings are same in Qty.

2.Make sure that status of all char are "5" valuated & closed.

[former_member1362664 · Accepted solution]

Thanks for your valuable reply.

But this time the total of result value is coming. But client need the count of result measured characteristic should come. Can you tell me the formula for that.

Please reply soon

[Former Member · Accepted solution]

There is no std way but you can use

User Exit

QEEM0029 User-Exit for Characteristic Overview Subscreen |

|QEEM0030 User-Exit for Subscreen: Characteristic Single Screen

[former_member1362664 · Accepted solution]

Dear Sir,

Can we use the formula in inspection plan e.g. C10010C10020 instead of e.g. A00010A00020.

As results are satisfactory.

Please reply soon

[Former Member · Accepted solution]

There is std way of specifying formula like for char C010, C020 , C030

C010C020c030 would be the formula for multiplication

[former_member1362664 · Accepted solution]

Ya.

As this C1 is for "No. of valid measured values for char." and I m just adding these numbers.

And this is working fine.