Inspection lot not being created against inspection type 10 or 02

[Former Member]

Hi

We need to inspect material at the time of goods being delivered to material. I did the following steps:

1. in SPRO, Assign Inspection Lot Origin to Delivery Type, against Delivery Type LF we mentioned insp. origin 10

2. Assigned insp. type 10 in material master QM view

3. Created Sales Order using the same material code

4. Created Outbound Delivery against Sales order, but when we press button for Post Good Issue, the system issues the message "Status of inspection lot 100000000004 / partial lot 000000 does not allow good issue" BUT NO INSPECTION LOT IS BEING SEEN WHEN WE USE QA32/QA02. I have also seen the QALS table using SE16 and no record for inspection 100000000004 is seen.

Please also note that

1) other inspection lots are being created and processed normally such as inspection origin 01, 14, 15, etc.

2) each time we try again to create delivery and press post good issue button, IL number is incremented say 100000000005, then 100000000006, 100000000007, so on.

3) the issue is the same for insp. origin 02

Please reply

Chris

[Former Member · Accepted solution]

Hello,

Check if this is helpful to you.