cancel
Showing results for 
Search instead for 
Did you mean: 

Smartform language problem

Former Member
0 Kudos

Hi

I have created a new outout type for V3( Billing ) and created a new smartforms for the same , but when i give the output

for the same though VA01 ,my chanes are not reflecting in the print priview in this case language is HR(Crotian) but when i go inside VA02 -goto -header -output and change the language to EN, the chages are geting displayed ,but my requirement is it should apper in HR languages also.

Kindly help me on the same

Accepted Solutions (0)

Answers (1)

Answers (1)

aidan_black
Active Contributor
0 Kudos

Hi,

When your application calls the function module of the smartform, the language key is set by this parameter CONTROL_PARAMETERS-LANGU. So if the application fills this parameter with language HR, then the HR language version of the smartform should be called.

In additon to this, you need to ensure that you use a device type that supports this language. e.g. device type I2SWIN or unicode deviec type SWINCF. Did you ativate the ssmartform after makng the changes in the HR version of the form?

Regards,

Aidan