UD selected sets

[rajesh_sutar2]

Hi Experts,

Please tell me how do set selected set in usage dicision which I created for plant.

I want system should trigger only those selected set for which I am giving UD for inspection lot of same plant

Soppose inspection lot XYZ created in plant 9999

I have created selected selected sets say QT01 for Usage dicision for plant 9999.

When I do UD for above inspection lot system should propose me selected set QT01 only in QA11.

How to configure this.

Regards.

[Former Member · Accepted solution]

In QCC3->inspection lot creation>select inspection type---->selected set in same plant

Use

If you set this indicator, you can only use usage decisions from selected sets that are in the same plant as the inspection lot.

Dependencies

Using the UD-selected set field, you can limit the pool of usage decisions to a single selected set.

[rajesh_sutar2 · Accepted solution]

Hi Sujit,

Thanks for your reply.

I have done setting as you said.

Now facing error while UD is "Selected set code does not exist, or data entered is incomplete"

As I have already created codes & selected sets for same plant.

[Former Member · Accepted solution]

But have you entered selected set in QCC3->inspection lot creation>inspection type

[rajesh_sutar2 · Accepted solution]

Hi Sujit,

I have not maintained selected set in inspection type configuration.

Now same I have maintained.

My problem get resolved time being.

Actually I have 3 selected sets in my plant. Now system proposing me only that selected set which I have mainted in inspection type.

My requirement is system should propose me all selected set which created for plant in UD.

Regards,

[Former Member · Accepted solution]

Actually I have 3 selected sets in my plant. Now system proposing me only that selected set which I have mainted in inspection type.

My requirement is system should propose me all selected set which created for plant in UD.

Well as per customization one selected entered in customization specifically that can only been seen in the selected set when you Tick on selected set related to plant .........

I am not sure how 3 selected sets are seen for a particular plant in UD but certainly this is not possible through customization,,,

One suggestion I can give you is combine three selected set .......create one & assign it to inspection type.

Otherwise there is no possibility to see three selected set plant wise

[rajesh_sutar2 · Accepted solution]

Dear Sujit,

Thanks for your continue reply.