How to include map in an application built with Visual Composer?

[Former Member]

Hello!

Is it possible to include map into a Visual Composer application? I want my application to show only data relevant for the certain region marked on the map. Or is it better to use Web Application Designer for this purpose?

Thanks for your opinions

[Former Member]

Hello Irina,

Yes, it's possible include a map in the application.

I created an example about this, using HTML iView and Google Maps website.

Do you know how can i post an article here on SDN?

Thanks

Daniel Nahas

[Former Member]

You can make your article a WIKI-page (e.g. under Step-by-step-guides) or you send it to me and I take care of it.

[Former Member]

hi, have you post anywhere the document about maps in visual composer?

thanks

[Former Member]

VC per se does not support maps. But you can always use the HTMLView and use a BW map behind that.

Mario

[former_member193545]

Hi

I have seen a map application included in a VC application, the map application was wrapped as a portal application, this enabled it to broardcast using the epcm event the coordinates on the map, a VC iview was built which had a signal in setup which received them and then you could use the coordinates to run the VC application.

Jarrod Williams

[Former Member]

There will be soon a HowTo paper available which gives a lot of examples of how to do that. So keep checking...

Mario