Transaction QS41 is running in display mode unable access in change mode

[Former Member]

Hi Guys,

Earlier they were able to run transaction QS41 in change mode,After the ECC 6.0 EHP4 upgrade it is running only in display mode.

System is giving the message that Client xxx has status 'not modifiable'.

Can any one give the inputs to resolve the problem.

Regards

kumar

[john_lutz]

Hello,

Check out notes 376134 and 210284.

Regards,

John

[Former Member]

Hello,

Already these Notes 376134, 381286, 356483 are set in the system.The problem is,In Dev system QS41 is working but where as in Qua ,Prd it is not.

Regards

Kumar

[Former Member]

Check with your basis team and ask them to open the t-codes for eding - I guess thru scc1. It's only basis setup. But in general qs41 will be open for editing in config client and the master data transported to all non prods. The t-code is open for editing in PROD also. Most of the copanies do this, if you have to have it open - ask your basis.

Thanks,

Ram

[Former Member]

Hi Guys,

Thanks a lot for your response.

Regards

Kumar

[Former Member]

In the production system, You cannot use QS41 in Update mode. Create a transport in QA or Dev system and have the changes transported.

See more details in the link below

http://wiki.sdn.sap.com/wiki/display/PLM/QS41Settingsinproductiveandtestclient