on 08-02-2006 9:05 AM
Hi All,
We are facing a problem in BPM with S/A Bridge.
In the BPM we are synchronously calling multiple
stored procedures. Each of these stored procedures
will take 10-1200Secs for sending back the reponse.
Last step in the BPM is to close the S/A Bridge.
But maximum time-delay allowed in XI between
opening and closing S/A bridge is only 100sec.
(Param - CHECK_FOR_ASYNC_RESPONSE_TIMEOUT)
So we are unable close the bridge. It is getting
time-out.
Is there any way to overcome this limitation ??
We are using XI SP15.
Thanks in Advance
Chemmanz
Hi Chemmanz,
The settings can be done SXMB_ADM -> Integration Engine Config -> Change Specific Config -> Add a new entry
Check the Category SA_COMM, see the help for its parameters.
By default the time out setting is 60 seconds and the maximum allowed is 1000 seconds.
Regards,
Abhy
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi Chemmanz,
You have to set the right value for icm/conn_timeout
This is explained detail in the note 824554
Regards,
Sridhar
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
77 | |
9 | |
9 | |
7 | |
6 | |
6 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.