on 02-16-2011 5:26 PM
Hello Folks
I want to switch operation modes RZ03 from "normal" to "Sgen" and I'm getting the following error
*************************************************************************************************************
Active op. mode: Normal
Sorted by server name
Server Name Services Status Configuration alerts
Server01 XXXXX Active Work processes, operation mode differ
*************************************************************************************************************
Do you know whats happens? any recommendations ?
This is my operation modes
*************************************************************************
List of operation modes
DUMMY Self-Configured Operation Mode
SGEN optimize for SGEN
normal normal operation mode
*************************************************************************
This is the configuration for modes
*********************************************************************************************
Productive instances and their WP distribution
Host Name Server Name Instance Profile
OP Mode Dia BP BPA Spo Upd Up2 Enq Sum
server01 server01 XXXXXXXXXXXXXXXXXXXXXX
SGEN 17 4 - 1 2 1 1 26
normal 11 7 - 1 4 2 1 26
*********************************************************************************************
Edited by: Cheiros on Feb 16, 2011 6:29 PM
Hello,
Perhaps SAP Note 12930 - Operation mode switching does not work
may be helpful here?
Regards,
Paul
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi,
Is this behaviour happens all the time when try to switch or after any particular activity , say restart or something?
Have you checked the configuration in RZ04 and SM63 and ensured that they are consistent with each other? Could you try to re-configure your RZ04 and import your profiles once again there?
Rajeev
Hello Cherios,
The common reason for the above error is Start profile, instance profile or total no. of processes are different from
the original configuration. Sometime it may so happen that the op mode configuartion you have now may be obsolete.I mean to say there might have been increase in the total no of WPs but your current configuration is referring to earlier no of total WPs.
In that case you need to delete the op mode configuration in RZ03 and recreate with correct distribution of total no of WPs available. Also make sure the SM63 entry is consitent b/w two op modes.
Regards
Vivek
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
80 | |
9 | |
9 | |
7 | |
7 | |
6 | |
6 | |
6 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.