on 02-15-2011 12:36 PM
Hi.
What does the entry in SSRVSERVICE do?
We have a scenario complaining about no entry in that table.
How will I get an entry for my logical system in the table?
Can I manualy make an entry in the table?
BR
Kalle
Hi ,
You should not enter manaully in the table...
You need to setup RFC-destination SM59 in both systems, and ports in both systems (WE21 and IDX2 respectively). Also set up your business systems in SLD and your partner profile in R/3 and integration scenarion.
Once the above is done then the entries will be there in the table...
Regards,
Sridhar
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Hi.
Our sending system is a virtual system.
The ABAP job collecting a file on the filesystem just reads the data and posts it as an Idoc.
Our setup is that the virtual system that we have created in the SLD post the Idoc on to the PI system also.
We have a "dummyport" for the file integration in WE21
SM59 konfigured towards the PI system.
IDX1 and IDX2 configured.
What I found in the SLD is that th PI teknikal system has a System Home on ****db I think it should be *****ci that's the correct host name on our PI system. The hostname ending with ci.
Could this be the fault?
BR
Kalle
Hello Kalle
What is the exact error and exactly how/where does it occur?
The SSRVSERVICE table is used to store logical systems. The search help in trx sxi_monitor uses the values from this table.
You can check the SSRVSERVICE table in trx SE16.
Regards
Mark
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
User | Count |
---|---|
87 | |
10 | |
10 | |
10 | |
7 | |
6 | |
6 | |
5 | |
5 | |
4 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.