QS51 / QS41 - Is it possible to create one set for all plants (code 3)?

[Former Member]

Hello,

Is it possible to create one selection set for all plants in QS51 or QS41? Our customer would like to have only 1 set for all plants to take the usage decision (code 3). This means a plant independent selection set. At this moment we have created a set for each plant. But because we use the same codes (A en R) for all plants we wonder if it possible to have only one.

Regards, Joyce

[former_member42743]

Yes, it is possible. In config though, you want to check the inspection type setup. There is an indicator in there called "Selected set in same plant". Make sure this is ticked off. Otherwise it requires a selected set in each plant. If you have already used your selected sets in production it may be difficult to get rid of them. You'll have to mark them for deletion and then hopefully they won't show up as available choices.

FF

[Former Member]

Thank you. I will try it and let you know if it works!

[Former Member]

Hello! Could you tell me in which part of the costumizing can I set this configuration?

Regards!!

Bárbara (Email = bcarrenca@gmail.com)

[former_member42743]

Quality Management-->Quality Inspection-->Inspection Lot Creation-->Maintain Inspection Types

FF