What is the purpose of the program /SAPSLL/MARC_UPLOAD_R3

[former_member433442]

Hi,

I transfered the master data to GTS through standard RFC connections.

In the documentation, i could see a program "/SAPSLL/MARC_UPLOAD_R3" to upload the plant specific data. What is the purpose of this program? Is it mandatory to use this program?

When i tried to upload data using this program, i am getting error as "No cust. Tariff number found for det.Procedure HTSCA"

Thanks & Regards,

Prabu

[Former Member · Accepted solution]

This program is used to load HTS numbers related to products in GTS product master. You must already have all HTS numbers master data in your GTS .

Thanks,

Renu

[Former Member]

Hi Prabu,

As per my knowledge, This program is to transfer the HTS data which is available in feeder system to GTS. This program can be used if the Tariff Codes are maintained in your feeder system and it is not mandatory.

The reason for the error might be because of the non-availability of the Tariff codes in your feeder system.

Mark if it is helpful...

Regards,

Shiva