on 02-11-2011 5:59 PM
Dear Guru,
good evening,
I have a question for you,
Iwork in this Scenario
ERP initial package for HCM PD - expert.
users want for infotype 0000 apply this rule:
is field MASSN has value = 09 then in transfer data the field MASSG have to value=06 while other values remain unchanged.
In my scrambling rule definitiion I created a condition set where for:
PA0000-MASSG field I applied condition set PA0000-MASSN = 09 then in target system PA0000-MASSG have to value 06.
I ran transfer data but in target system I haven't modification on PA000 field MASSG.
How can I transfer the data request by users?
Thanks in advance for your precious support
Best regards
Max
Hi Masx, one idea: you can see that in condition-sets there is two bottons:
Switch field to before scram ►▫
Switch field to after scram ▫►
I think you have to put in your condition-set ►▫ before the conditions details.
Hope it heps.
Manuel
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.
Dear Manuel.
thanks a lot for your support.
I made a mistake during the condotion set definition:
when I defined the mapping <table><field> (field list) I choosed, in key-set phase, only one field of the primary key (PERNR ..as ususal)
For this type of condition set I have to choiche every field of primary key (EG: for field list =PA0302-MASSN I have to choice, im key set definition evety field of primary key like
PA0302-MANDT, ...PERNR,...SUBTY, ...OBJPS, ...SPRPS, ...ENDDAS,...BEGDA, ...SEQNR)
The condition detail is "switched after scram" ▫►.
Thnaks again
Max
User | Count |
---|---|
82 | |
10 | |
10 | |
9 | |
6 | |
6 | |
5 | |
5 | |
4 | |
3 |
You must be a registered user to add a comment. If you've already registered, sign in. Otherwise, register and sign in.